TX Frequencies: 5850 to 6425 MHz
RX Frequencies: 3625 to 4200 MHz
AnaSat Extended C-Band VSAT Transceiver
includes: 70 MHz IF input, output (type N for up to 40W,
CPR137 for higher powers) fixed gain, M&C, independent TX/RX frequency
and gain control, 65K LNC and 100 to 240 VAC auto-ranging power supply.
Note: One (1) LNC covers the entire Receive Frequency band.
Single
Enclosures Transceivers:
Part Number
Description
30792 AnaSat - 0 dBm
EC-Band Transceiver
30793 AnaSat - 2W EC-Band Transceiver
30794 AnaSat - 5W EC-Band Transceiver
30795
AnaSat - 10W EC-Band Transceiver
30968
AnaSat - 10W EC-Band Transceiver (without fan)
30796
AnaSat - 20W EC-Band Transceiver 31005 AnaSat - 30W EC-Band Transceiver (CPR137 W/G Out)
30800
AnaSat - 40W EC-Band Transceiver
Note: The following single enclosure Transceivers are provide with
CPR137G Waveguide RF Output Interface.
31237 AnaSat - 50W EC-Band Transceiver
........................................................................
31508 AnaSat - 60W EC-Band Transceiver
........................................................................
31509 AnaSat - 70W EC-Band Transceiver
........................................................................
31285 AnaSat - 80W EC-Band Transceiver
........................................................................
31295 AnaSat - 100W EC-Band Transceiver
...................................................................... 30570-65 LNC, 65K, Standard (Included)
30935 Accessory Kit – (Included)
- Includes: Transceiver mating connectors, AC power cord 15' , 10' LNC
cable, 10' M&C cable, mastic tape, Supervisor M&C software disk, Operating
Manual, LNC mounting hardware and gaskets.
...................................................
Options
30570-35 LNC, 35K Option (Required for each Transceiver)
10917 TX Reject Filter
11706-003 Cable, Coax, low loss flexible, RF output, 3'
31198-003 Cable, LNC to Transceiver, length 3'
12104 Installation Kit for 0dBm to 100W Single Enclosure Transceiver for
Prodelin and Channel Master offset antennas. Includes brackets and mounting
hardware to install on antenna feed support arm (3' flex waveguide or low
loss coax sold separately)
31018 Terminal, Handheld (connects to Transceiver 18 Pin M& C Connector)
|
